You are here:Home > Attenuators, Couplers, and Splitters
These additions to your test equipment setups enhance the ability to make accurate and reliable measurements.
Sort By:
Page of 1
Attenuator 10 dB 300W Very High Power N-f to N-m Attenuator 20 dB N Male to N Female Low Power Attenuator 30 dB High Power N-f to N-m
A Very High Power (300W) RF Attenuator designed for use with the D-series Base Radios. By using an external high power attenuator you control the mismatch uncertainty and provide a clean reduced level RF signal to your test equipment at the same time. Keeping high power levels away from your test equipment is always a good idea. A must have item for use with some signal generators such as the Aeroflex 2975 and Anritsu S412E. Provides 20 dB of attenuation for those sources that do not provide a low enough RF level for receiver testing. These attenuators will also improve accuracy by reducing mismatch uncertainty. Insertion Loss test data at 150, 450, and 900 MHz is included. A High Power (150W) RF Attenuator perfect for transmitter testing. By using an external high power attenuator you control the mismatch uncertainty and provide a clean reduced level RF signal to your test equipment at the same time. Keeping high power levels away from your test equipment is always a good idea. Even communications monitors with a rated input of 100W or greater benefit from this. By keeping the heat out of your test equipment you increase accuracy and longevity. Also, pay close attention to that power rating: it is usually only applicable to a 20% duty cycle! Includes actual measured Attenuation and Return Loss data.
Attenuator 40 dB High Power N Female to N Male CPL2002 Dual Coupler N-f to N-m Medium Power 100 to 2000 MHz Termination 50W
Termination 50W
Our Price: $399.00
A High Power (150W) RF Attenuator perfect for transmitter testing. By using an external high power attenuator you control the mismatch uncertainty and provide a clean reduced level RF signal to your test equipment at the same time. Keeping high power levels away from your test equipment is always a good idea. Even communications monitors with a rated input of 100W or greater benefit from this. By keeping the heat out of your test equipment you increase accuracy and longevity. Also, pay close attention to that power rating: it is usually only applicable to a 20% duty cycle! Includes actual measured Attenuation and Return Loss data. 30 to 40 dB Broadband Coupler perfect for Receiver or Transmitter testing. Coupled Loss and Insertion Loss are stable and documented. Provides a significantly better match on all ports than a traditional Iso-Tee does. The directivity of the coupler isolates your test from reflections. A 50 Watt 50 Ohm Termination that is supplied in the DBR Kit.  Termination may be square, hex, or round depending upon availability.